Property investing

Victoria’s Rental Energy Efficiency Standards From 1 March 2027: What Landlords Must Do

Omar De Guise · Citadel Agency · 21 November 2026 · 9 min read
Living room in a rental home with a wall mounted split system air conditioner above the window
In this article 12 sections
  1. Key takeaways
  2. What are Victoria’s new rental energy efficiency standards?
  3. Which standards start when a new lease begins?
  4. Do you have to replace a working heater or hot water system?
  5. When does draughtproofing start, and why does gas matter?
  6. What happens on 1 July 2030?
  7. Which events trigger which standard? Citadel’s trigger map
  8. What exemptions apply to apartments and heritage homes?
  9. Are there discounts for rental providers?
  10. What should landlords do now?
  11. Frequently asked questions
  12. Sources

From 1 March 2027, Victorian rental properties must start meeting new minimum energy efficiency standards for heating, cooling, hot water, shower heads and ceiling insulation, with draughtproofing following from 1 July 2027. Most standards are triggered by an event, such as a new lease, a lease rolling to month to month, or a heater or hot water system failing beyond repair, so working out what applies to your property comes down to timing.

Checked against Consumer Affairs Victoria and the Victorian Government energy website on 20 November 2026.

Key takeaways

  • The standards cover 6 areas: heating, cooling, hot water, shower heads, ceiling insulation and draughtproofing.
  • Shower heads, ceiling insulation and cooling apply from 1 March 2027 at the start of a new rental agreement or when an agreement converts to month to month.
  • Heating and hot water apply from 1 March 2027 only when the existing system fails and cannot be repaired. A working system that meets the existing standard does not have to be replaced.
  • Draughtproofing applies from 1 July 2027, and every rental must have cooling from 1 July 2030 whatever the lease status.
  • Exemptions can apply, for example where heritage laws or owners corporation rules stop an installation. Keep proof if you rely on one.
  • Discounts are available through the Victorian Energy Upgrades (VEU) program.

What are Victoria’s new rental energy efficiency standards?

Consumer Affairs Victoria (CAV) says new minimum energy efficiency standards for residential rental properties come into effect in phases from 1 March 2027. They sit on top of the existing rental minimum standards, which already require things like a fixed heater in the main living area.

CAV describes the changes as part of the Victorian Government’s wider electrification and energy efficiency reforms, aimed at reducing energy costs for renters and improving the comfort of rental homes. The rules are set out in the Residential Tenancies Amendment (Minimum Energy Efficiency Standards) Regulations 2025.

The key point for rental providers is that each standard has its own trigger and start date. Some apply when a lease starts, some only when an appliance dies, and one applies to every rental from a fixed date.

Which standards start when a new lease begins?

Three standards apply from 1 March 2027 at the start of a new rental agreement, or when an existing agreement converts to a month to month agreement.

Shower heads

Every shower must have a water efficient shower head with a minimum 4 star WELS (Water Efficiency Labelling and Standards) rating. CAV says that if the age, nature or structure of the plumbing means a 4 star shower head cannot be installed or will not work effectively, a 3 star shower head must be installed instead.

Ceiling insulation

Insulation with a minimum R-value of 5.0 must be installed by a qualified installer in all ceiling spaces, or parts of ceiling spaces, where there is no insulation now. You cannot install it yourself to meet the standard.

If the property already has ceiling insulation, you do not need to add more, regardless of its rating or type of material. CAV also says an electrical safety checklist must be completed, and any electrical issues fixed by a licensed electrician, within 30 days before the insulation goes in.

Cooling

An energy efficient fixed cooling system with an outlet in the main living area must be installed at the start of a new agreement or a conversion to month to month. If the property already has a fixed cooling system, the standard applies when that system fails and cannot be repaired.

Energy efficient cooling means either a non ducted electric air conditioner or heat pump with a 3 star or above cooling rating, or a ducted system with a Total Cooling Seasonal Performance Factor of 3.8 or above, in each case for the property’s climate area.

Do you have to replace a working heater or hot water system?

No. CAV is clear that the heating and hot water standards are triggered only when the existing system breaks down and cannot be repaired.

  • Heating. From 1 March 2027, when an existing fixed heating system fails and cannot be repaired, it must be replaced with an energy efficient fixed electric heating system with an outlet in the main living area. That means a non ducted electric air conditioner or heat pump with a 2 star or above heating rating, or a ducted electric system with a Heating Seasonal Performance Factor of 3.2 or above, for the climate area. If the property has no heating, or the heater does not meet the existing minimum standard, you must install one that does straight away. Portable heaters do not meet the standard.
  • Hot water. From 1 March 2027, when an existing hot water system permanently fails and cannot be repaired, it must be replaced with an energy efficient electric system: a heat pump water heater or an electric boosted solar water heater.

CAV points out that a reverse cycle air conditioner can provide both heating and cooling, so one appliance may satisfy both standards.

When does draughtproofing start, and why does gas matter?

From 1 July 2027, rental providers must draughtproof all external doors, windows and unsealed wall vents. Like the shower head and insulation standards, it applies at the start of a new agreement or a conversion to month to month.

Gas changes the order of work. If the property has gas appliances, CAV says a gas safety check must be done before any draughtproofing begins, and it must be less than six months old when the draughtproofing is completed. If the check finds un-flued or open-flued gas appliances, or a gas cooktop without a rangehood, draughtproofing should not go ahead, because sealing the home can create health and safety risks.

We cover the two yearly gas and electrical checks that already apply to every Victorian rental in our guide to rental safety checks in Victoria.

What happens on 1 July 2030?

The cooling standard has a second phase. From 1 July 2030, all rental properties must meet the cooling standard, regardless of whether a new lease has been entered into. A rental with the same renter on a long fixed term agreement still needs compliant cooling by that date.

Which events trigger which standard? Citadel’s trigger map

CAV sets the rules out standard by standard. Investors usually meet them event by event, so we have regrouped the same official requirements by the event that sets them off. Each line comes from the CAV standards page.

  1. A new lease is signed, or a lease rolls to month to month (from 1 March 2027): check shower heads (4 star WELS), ceiling insulation (R5.0 where none exists) and fixed cooling in the main living area. From 1 July 2027, add draughtproofing, with a gas safety check first if there is gas.
  2. The heater dies and cannot be repaired (from 1 March 2027): replace it with an efficient fixed electric heater in the main living area.
  3. The hot water system dies and cannot be repaired (from 1 March 2027): replace it with a heat pump or electric boosted solar water heater.
  4. An existing fixed cooling system dies and cannot be repaired (from 1 March 2027): replace it with a system that meets the cooling standard.
  5. 1 July 2030 arrives: every rental must meet the cooling standard, whatever its lease status.
  6. Any time you rely on an exemption: keep proof that it applies, as CAV advises.

A note from our team: the dates that matter most for an investor are usually lease dates, not 1 March 2027 itself. Put your current lease end dates next to this list and you will see which upgrades are likely to fall due first. When you are buying, ask the selling agent for the lease end date, the age and type of the heater and hot water system, whether there is ceiling insulation and whether there are any gas appliances. Then add any likely upgrade cost to your figures in our cash flow investment calculator.

What exemptions apply to apartments and heritage homes?

CAV says exemptions may apply where compliance is not possible, and lists the most common ones under each standard. Examples include:

  • heating, cooling or hot water supplied through a centralised building system, which CAV notes is common in apartments
  • installation not permitted under heritage laws or owners corporation rules
  • insufficient space for an external compressor unit, a heat pump or rooftop solar panels
  • insufficient ceiling space for insulation, or a ceiling space that is not safely accessible

An exemption from the efficiency standard does not remove the existing minimum standards. For example, CAV says that if a heating exemption applies, you still need a fixed heater in the main living area. If you own or are buying an apartment, read our guides on how to buy a unit and strata records, since owners corporation rules can decide what you are allowed to install.

Are there discounts for rental providers?

Yes. CAV says every upgrade under the new standards is eligible for a Victorian Energy Upgrades discount. The Victorian Government energy website lists, as at its 9 October 2026 update, discounts for rental providers of up to $1,610 to replace a gas space heater with an efficient reverse cycle air conditioner, up to $5,530 to replace a ducted gas heater with a ducted reverse cycle system, and up to $560 to replace a gas hot water heater with a heat pump water heater. CAV says a VEU discount for ceiling insulation is available from 1 October 2026.

Offers and eligibility change, so check the current figures on the official pages before you book any work.

What should landlords do now?

General information only. Talk to your property manager and licensed trades about your own property.

  1. List your lease dates. Note when each Victorian lease ends or converts to month to month after 1 March 2027.
  2. Record what is installed. Heater type and age, hot water type and age, cooling, shower head ratings, ceiling insulation and any gas appliances.
  3. Plan replacements before they fail. A heater or hot water system that dies in winter must be replaced with a compliant system, so know your options and costs in advance.
  4. Book gas checks before draughtproofing. If there is gas, the check must be less than six months old when the work is completed.
  5. Check exemptions early. Ask your owners corporation or heritage adviser before you plan work, and keep written proof.
  6. Keep proof of every installation. CAV encourages rental providers to keep proof of installation and appliance information.

Citadel Agency is a licensed buyers agency (licence 092247L) that helps investors buy in Melbourne, across Victoria and interstate. Learn more on our Melbourne buyers agent page.

Frequently asked questions

When do the new rental energy efficiency standards start in Victoria?

Consumer Affairs Victoria says they come into effect in phases from 1 March 2027. Draughtproofing starts on 1 July 2027 and all rentals must have compliant cooling from 1 July 2030.

Do I have to replace a working gas heater in my rental?

No. The heating standard applies only when an existing fixed heater fails and cannot be repaired. It must then be replaced with an energy efficient fixed electric heater in the main living area.

What triggers the shower head and insulation standards?

From 1 March 2027, the start of a new rental agreement or the conversion of an existing agreement to month to month.

Do I need to top up existing ceiling insulation?

No. If the property already has ceiling insulation, regardless of its rating or material, you do not need to add more. Insulation of at least R5.0 is required only where there is none.

Are apartments exempt?

Not automatically. Exemptions can apply, for example where heating or hot water comes from a centralised building system or owners corporation rules do not permit an installation. Keep proof that the exemption applies.

Can I get a discount on the upgrades?

Consumer Affairs Victoria says every upgrade under the new standards is eligible for a Victorian Energy Upgrades discount. Check current offers on the official website.

Sources

Want help checking what a Victorian rental will need before you buy? Book a free strategy call with our team.

General information only. It does not take into account your objectives, financial situation or needs. Speak to a qualified professional before acting.

Written by Omar De Guise, Citadel Agency
Citadel Agency is a licensed, data-led buyers agency for property investors (licence 092247L), with $200M+ in deals transacted and 5.0 from 150+ Google reviews. About us

General information only. It does not take your objectives, financial situation or needs into account and is not financial, tax, credit or legal advice.

Keep reading

Related articles

Want a second opinion on your next purchase?A licensed buyers agent will look at your budget, borrowing and goals.
Book a free strategy call